Артикул | AX10 |
---|---|
Светодиодный модуль | RGBAW |
Цвета | RGBAW |
Общая мощность светодиодов | 135 Вт |
Световой выход при 4000K | 3350 люмен |
Освещенность при 4000К на 2 м | 10350 люкс |
CRI (Ra)/ TLCI 3200- 6500 K* | ≥96 |
Угол раскрытия луча | 13° |
Стробоскопические эффекты | 0 – 25 Гц |
Количество пикселей | 1 |
Время работы от аккумулятора | до 20 часов |
Ресурс аккумулятора | 70 % после 300 циклов |
Время зарядки (номинал) | 7 часов |
Вход постоянного тока | Нет |
Разъем питания постоянного тока | Нет |
Вход переменного тока | 90-264 В переменного тока; 47/63 Гц ~ 1,0 А/ 230 В переменного тока |
Разъем питания переменного тока | PowerCON TRUE1 IN/OUT |
Проводной DMX | Нет |
CRMX-приемник | Встроенный |
Беспроводные протоколы | CRMX, УВЧ |
Диапазон беспроводной связи | CRMX/УВЧ до 300 м |
ИК-управление | Да |
Материал корпуса | Алюминий |
Степень защиты | IP65 |
Рабочая температура окружающей среды | 0 – 40 °C / 32 – 104 °F |
Вес | 7,98 кг |
Размеры Д х Ш х Г | 279 мм x 296 мм x 253 мм |
Варианты монтажа | резьба 1/2"-13 UNC, проушина для страховочного троса |

Технические характеристики
Что внутри?
- 1 x AX10 SpotMax (AX10)
- 1 x 32° рассеивающий фильтр (AX10-DDSK)
- 1 x фильтр для заливки стен (AX10-WWDSK)
- 1 x кабель Powercon True1
Доступные версии
- AX10 SpotMax (с кабелем ЕС) (AX10-EU)
- AX10 SpotMax (с кабелем США) (AX10-US)
- AX10 SpotMax (с кабелем для Великобритании) (AX10-UK)
- AX10 SpotMax (с кабелем для Китая) (AX10-CH)
- AX10 SpotMax (с кабелем для Австралии) (AX10-AU)
Радиочастотные характеристики
Wireless Modules | Modulation | ERP (Transmitter) | Channel Count |
---|---|---|---|
EU: UHF***(863-870MHz) | FHSS | <25mW | 47 |
USA: UHF (917-922.20MHz) | FHSS | <25mW | 53 |
AUS: UHF (922.30-927.50MHz) | FHSS | <25mW | 53 |
SGP: UHF (920.50-924.50MHz) | FHSS | <25mW | 41 |
KOR: UHF (917.9-921.5MHz) | FHSS | <25mW | 10 |
RUS: UHF (868.75-869.12MHz) | FHSS | <25mW | 66 |
JPN: UHF (922.80-926.40MHz) | FHSS | <25mW | 19 |
CRMX (2402-2480MHz) | FHSS | – | 79 |
***General allocation of frequencies for use by short-range radio applications Spectrum usage regulations:
Frequency range in MHz1) | Maximum equivalent radiant power (ERP) | Additional parameters / frequency access and interference mitigation techniques |
---|---|---|
865 – 868 | 25 mW | Requirements for frequency access and mitigation techniques3) Alternatively, a maximum duty cycle2) of 1% can be used. |
868,0 – 868,6 | 25 mW | Requirements for frequency access and mitigation techniques3) Alternatively, a maximum duty cycle2) of 1% can be used. |
868,7 – 869,2 | 25 mW | Requirements for frequency access and mitigation techniques3) Alternatively, a maximum duty cycle2) of 0.1% can be used. |
869,40 – 869,65 | 500 mW | Requirements for frequency access and mitigation techniques3) Alternatively, a maximum duty cycle2) of 10% can be used. |
869,7 – 870,0 | 25 mW | Requirements for frequency access and mitigation techniques3) Alternatively, a maximum duty cycle2) of 1% can be used. |
1) The use of adjacent frequency bands within this table as a single frequency band is permitted, provided that the specific conditions for each of these adjacent frequency bands are met. 2) „duty cycle“ means the ratio of Σ(Ton)/(Tobs) expressed as a percentage, where ‚Ton‘ is the ‚on-time‘ of a single transmitting device and ‚Tobs‘ is the observation period Ton is measured in an observation frequency band (Fobs). Unless otherwise specified in this general allocation, Tobs is a continuous period of one hour and Fobs is the applicable frequency band in this general allocation (table). 3) Frequency access and interference mitigation techniques shall be used whose performance level at least meets the essential requirements of Directive 2014/53/EU or the Radio Equipment Act (FuAG). Where relevant techniques are described in harmonised standards, the references of which have been published in the Official Journal of the European Union pursuant to Directive 2014/53/EU, or parts thereof, performance shall be ensured which is at least equivalent to those techniques.